Gutters are perhaps one of the most overlooked roofing structures, but they are as important as the entire roofing system. Your gutter protects other housing structures from water damage. This makes gutter installation paramount. This piece focuses on how to install your house gutters.
Take measurements of the roof
Gutters are typically attached to the fascia and run along the lengths of the roof. The end of a channel should be linked to a downspout. Using the measurements of the roof, purchase gutters customized to those figures.
Purchase materials
In addition to purchasing gutters the length of the roof, shop for fascia brackets, downspouts, gutter guards, and nails.
Start the installation process
Begin the project by marking a starting point on the gutter and the roof. Consecutively, use your measurements to mark the endpoints on the gutter, before trimming the excess edges.
Attach the gutters
Drive a nail into each starting point while firmly holding the fascia strategically beneath the roof. Mount the gutters on the fascia. They should be seated in a position that holds all dripping water from the room without allowing any to sip out. Repeat the process with all the gutters and fascia. Attach the gutters to the fascia once they are all in place using screws.
Attach the downspouts
Using your measurements, you should have accurate figures on the size of the downspout required. Create a V-shaped hole at the end of the gutters in which the downspout will fit. You could use a pre-installed outlet to save you the time and energy in customizing the downspout outlet. Attach the downspout to the gutters via your outlets using screws. You may apply a sealant for more reinforcement.
There you have it! A simple guide on how to install your house gutters. If the process gets too technical for you, consider calling the experts. Reach us now through our contact information for all your roofing needs.